compressive strength test of brick

By | November 23, 2013

compressive strength test of brick according to Indian standard

This article describes the test approach to determining the compressive strength of solid bricks. One can refer to IS: 5454:1976 for more information with regards to the test procedure. The dimensions for area calculation should be measured to nearest 1 mm.It should been sure before continue the test procedure that each of the tools and equipments used is calibrated. For guidance regarding to selection of specimen, IS 5454:1976 shall be refereed.

Tools and equipments required

Compression testing machine and the compression plate.

Preparing brick specimen for testing

To accomplish smooth and parallel surface, remove unevenness by grinding. For 24 hours, submerged the brick specimen to room temperature. Remove specimen and remove excess moisture. With cement mortor, fill the frog and gaps in bed faces. Wrap the specimen in wet jute bag for the period of 24 hours. After this again immerse the specimen in clean water for three days.After three days,remove the specimen and wipe out excess moisture on the surface.

Compressive test procedure

With frog facing upward,place the specimen between two to three plywood sheets. The thickness of each plywood sheet should be about three mm. Also make sure the placement of sheet to be in the centred between the plates. Now apply the load axially at uniform rate of 14 N / mm 2 per minute. The application of load will be continue till failure of sample occurs. Ensure the load at failure should be maximum which is indicated by no incremental value on dial gauge

Calculation of compressive strength

The compressive strength of bricks will be calculated by following formula

Compressive strength in N/mm2 = Maximum load at failure in N(kgf) / Average area of the bed faces in mm2

One thought on “compressive strength test of brick

Leave a Reply

Your email address will not be published. Required fields are marked *